Club 80-90 Forums

Quick question, what size reducers needed to splice into a T25 fuel line to fit an Eberspacher D2?

Winchweight wrote:Quick question, what size reducers needed to splice into a T25 fuel line to fit an Eberspacher D2?

I fitted the T piece just after the fuel filter. I'm not 100% but 7mm equal T springs to mind.

8mm on the exit/entry points where its cut/put into fuel line. The Leg of the T that is at 90' to these two is 4mm

Thanks guys. Mario did tell me but Alzheimer's kicked in before I got home.

I cut mine in right by the outlet from the fuel tank, pump fitted quite close to it on the inner chassis member

Thanks mate. I expect that's where Mario will put it too.