Club 80-90 Forums

I'm rewiring my heater blower with new resistors from Brickwerks - anyone know how many amps it draws? Just want to use the correct new cables.

i asked the same question a while back.... https://club8090.co.uk/forum/viewtopic.p ... nt+fan+amp" onclick="window.open(this.href);return false;

Good shout lloydy - job done!

I'd probably go for 2mm thin wall (25amp) or even 3mm2 standard (27.5amp) as standard 2mm2 is rated at 17.5amp so a bit close to the 12amp draw of a new motor.
You don't want the wires getting warm or the extra resistance not allowing the fan to spin at full power.
Martin