Page 1 of 1
Where to fit a sender for a water temp guage?
Posted: 07 Nov 2013, 22:37
by chuggers72
Ok I ve had a sift through the forum and can find a shed load on fitting oil pressure/temp gauges but not a lot on the best place to fit the sender for a new water temp guage - any ideas anyone
Re: Where to fit a sender for a water temp guage?
Posted: 08 Nov 2013, 08:03
by ghost123uk
Just curious, what is up with the one you currently have ?
Re: Where to fit a sender for a water temp guage?
Posted: 08 Nov 2013, 12:13
by kevtherev
best place is in or on the thermostat housing.
This is where the cooled coolant arrives after warm up.. and the hot coolant during warm up..then mixes together
wait
there's one already there
Re: Where to fit a sender for a water temp guage?
Posted: 08 Nov 2013, 14:41
by chuggers72
I think I'm suffering from an extreme case of 'needle paranoia' and have lost all faith in my existing gauge as its all over the place! ! Fancy putting in a digital one - had a bit of banter with ghost over this some time ago but finaally getting round to doing something about it! !!