Club 80-90 Forums

I've tried to ask in Technical but have not received a reply so I'm trying here (sorry to trespass). Anyone know what size lacing tool I need to buy to fit the black plastic trim into the side window rubbers in my Autosleeper please, or anyone able to tell me how to find out/work it out? If I measure across the widest part of the trim do I get that size or do I need something a size larger. Sorry if this sounds a dumb question. I have tried google, WIKI etc but not been able to determine which I need. Many thanks folks.

Do you want to borry mine ? Can send it tomoro if you do , should all be set up ready, don't know about size, I got one with different sized inserts and just picked one that fitted my trim , Daz

Dazco wrote:Do you want to borry mine ? Can send it tomoro if you do , should all be set up ready, don't know about size, I got one with different sized inserts and just picked one that fitted my trim , Daz

Thats a great offer, thank you. You have pm. (or you will have when I send it in a few minutes).

Keith.That would probably be because you hijacked someone else's thread,instead of starting your own.

I've tried to ask in Technical but have not received a reply

Haha.borrow mine if you don't get sorted

Dazco, Mike

Any chance of a photo of yours? I need to get one too, and a photo of one that works would help to narrow down the choice.

ok these are the good ones, forget the price, they are robbers, i can get them for under £20 last i looked, i have a genuine clayton one from the 60's still going strong
http://www.frost.co.uk/automotive-winds ... -tool.html" onclick="window.open(this.href);return false;
there is also the simple loop on a rod and to be honest they also work good enough
not got a picky nto hand
mm

I used the jk diamond lacing tool when I did mine worked fine
As sais by mm its just a piece of wire on a rod
Probably get them cheaper than jk
I can measure it if needed

R0B wrote:Keith.That would probably be because you hijacked someone else's thread,instead of starting your own.

I've tried to ask in Technical but have not received a reply

I know, very naughty of me. Sorry.(And the above wasn't meant as a criticism, I was just trying to explain why I had put a Tech question in General Chat so that I wouldn't get a rollacking from a moderator). Ouch, that slap on the wrist hurt. It does show that you read the posts though doesn't it.
Anyway, thanks everyone who's offered to help, I'm sorted via Dazco

All sorted now. Trims back in place. Many thanks to Hakuna Matata and Dazco for the great advice (though not sure what size hammer you meant ) and to Dazco for the loan of the equipment. (Had to be careful how I worded that one