Page 1 of 1
How to fix a hole in my exhaust
Posted: 04 Oct 2006, 10:15
by irishkeet
Hi all
I have a small hole in my exhaust about the size of a nail head...
I was wondering if anyone knows a quick (good) fix for this.
Any pastes or sealers that will fill the hole or am I better to weld it?
thanks
irishkeet
Posted: 04 Oct 2006, 11:12
by Dubstar
For small holes like that I use exhaust paste and silver foil. Get it nice and wet-the paste-and smooth it in and round the hole, then put some silver foil over it. And don't forget to let it dry, or it may get blown out when you start the engine up. If you can get the exhaust warmed up first then that'll help. Just don't burn your hand on it, and give it a good wire brushing before you apply the paste. I can't weld though, so I can't give an opinion on that.
Posted: 04 Oct 2006, 11:51
by steve8090
When you bring it back to me for its first service I'll put a spot of weld on it for you.
Posted: 04 Oct 2006, 11:59
by Louey
Posted: 04 Oct 2006, 12:28
by irishkeet
Steve your a star
Dubstar thanks for the help & advice
Louey (is it Louey from techenders?) you forgot the jublee clips
Posted: 04 Oct 2006, 17:27
by Louey
irishkeet wrote:
Louey (is it Louey from techenders?) you forgot the jublee clips
yep same wierdo
how you doing?
Posted: 05 Oct 2006, 10:45
by irishkeet
hey
mate how are you?
are you going to the lobbs field weekend mentioned on the JK site?
how is the new job going?
was good to see you @ vanfest albeit briefly, cable worked a treat
all the best
keet
Posted: 05 Oct 2006, 15:09
by Louey
I'm not too bad mate - not gonna make Lobb fields, going away in the middle of week after it
