Any Engineers out there?
Posted: 20 Aug 2013, 19:05
Anyone on here an engineer that can produce a 1/4" (6mm) engine-turned sheet of 20g S/S for me (similar to a Duesenberg dash). Approx. 18" X 10". It’s for a car we are building for a client and he has specifically requested this in part of his dash.
I know there is a lot of talent on here & someone must be able to do it.
Thanks guys
Tim
P.S. sorry mods if this is in the wrong place, didn't know where it should go.
I know there is a lot of talent on here & someone must be able to do it.
Thanks guys
Tim
P.S. sorry mods if this is in the wrong place, didn't know where it should go.
