Club 80-90 Forums

Has anybody any ideas where I can source a thermostat for my T25. 2lt A/C. Mine has given up the ghost.

Can we run these motors without one? Dont want to melt me engine!

Thanks

Scouse

Could try one of the traders on here or Breaker..be sure to test in hot water before fitting...
Yes you can run without one ..providing your cooling flaps stay open...read below

On startup on a normal working system the cooling flaps are closed to allow the engine to reach normal operating temp quickly and the thernostat expands as it is heated by the block and allows the cooling flaps to open and hence cool the cylinders. If the thermostat fails it usually fails in the expanded position so the flaps will stay open and still be cooling the engine. To be on the safe side if you know the thermostat is knacked, disconnect the cable and ensure that the flaps stay OPEN. the spring on the bar should default them open. The engine will run fine like this , but it is advisable to replace the thermostat as soon as you can get hold of one, as the engine will take longer to warm up hence wear at a faster rate than its design..
Hope this helps
Al

Many thanks. at least I am still mobile.

Have placed a request on the wanted forum.

Scouse

https://club8090.co.uk/wiki/Pe ... thermostat
click your heal together three times and say "there no place like wiki...!!"

Thanks very muck for the link hacksawbob,

i take it the type 1 beetle/bus thermostat featured is not for a 2 ltr, but works just the same opning the flaps a bit sooner?

Owe you a drink if we ever meet up

Scouse