Club 80-90 Forums

Hi
I have a 1988 Petrol with 4 speed box.
It is hard to get into first gear.
I suspect the gear linkage needs adjusting.
Found lots of post about gear linkage needs adjustment, but no mention of how its done.

Please could someone tell me how to do this....................?
Many Thanks.

Hello..

This current thread may help in Technical..

Gear shift part idenification (leading over the Petrol tank)

I shall be doing the whole thing soon..

Cordialement,

Have you tried looking in the WIKI?

see my post in syncro in answer to Rogue Trooper, 4 speed same a syncro

but may be that the guides need a repair

Have you tried looking in the WIKI?
Yes.....................
?

This one Aidan ?
loosen the pinch bolt
in the cab move the stick left to right across the gate in neutral a couple of times then over to the right and hold it there whilst the pinch bolt is tightened, ideally 2 peeps


Thanks.
Sounds simple....................................
Is it that simple ?
Is it likely to cure difficulty in getting into first ?

adjustment is that easy if all the parts of the linkage are in good condition but it will only fix the problem if it's an adjustment issue, as I said it may be that the nylon guide below the gearstick is damaged and needs repair or some other part of the linkage is worn and in need of replacement
ensure that the pinch bolt is correctly fitted with the bolt alligned in the cut out in the shaft, if it's horizontal it's in the wrong place

Many Thanks.