Club 80-90 Forums

One day they worked the next they didn't

Both bulbs ok, any ideas ?

Stanman
(not technically minded, but guessed you'd work that out already )

Switch.....on the gearbox.
Just pull the plug off and use a paper clip to bridge the terminals (reverse gear selected with ignition on) to verify that the switch itself is at fault.

Martin

Just a heads up but there is no requirment by law or MoT for reverse lights!

Had this the other day. The flat loom terminals stretch from engine vibration: pull them of and gently squeeze them down a little with pliers so that they grip the blade on the switch firmly. Refit the wires, either way round. Hey presto! Reversing lights.

Or the switch has worn out as said. If you do replace it, you'll need to test with and without washers under it to get just the right clearance for lights to activate correctly

Nice one, just as I expected, some great help

Thanks all

Stanman

Brickwerks for a new switch?