Club 80-90 Forums

Can somebody confirm a couple of things for me please?
Rear gearbox mounts order of assembly , working from the bottom is it nut,lock washer, gearbox lug, big washer, half spherical plastic thing, body bracket, half spherical plastic thing, big washer, lock washer, nut?
Secondly, clutch slave cylinder, pipe fitting facing forward or backwards?
I really should get a manual.

from memory you correct, nut, big washer, conical rubber thing, plastic washer (which slots in to the rubber thing) then gear box then the same again on top.

cant rember about the clutch cylinder.
neil

Oilline wrote: I really should get a manual.

Dont beat yourself up, I have never looked inside one either.

Jed

From below..nut, thick small washer, lug, big washer, rubber donger, plastic washer, mounting plate, plastic washer with interlock engaged with lower one, rubber, big washer, bolt...


Or put the bolt in from below to make life easier.

Don't skimp on the small thick washer, without it the lugs are in danger or getting splayed as the nut sinks into the softer alloy.