Club 80-90 Forums

Don't know if this is the right forum for this, but here goes.

Removed the breather tank on the passenger side today to check condition of wheel arch and treat then dinitrol. Went to refit it it, but can I? Can I buggery.

It just wont sit back in the hollow and slip over the bolt. Snapped the bloody valve off too.

Any one know what I'm doing wrong?

Thanks in advance.

fill the indentation in bodywork with vaseline then bolt breather tank back in loosely then push breather tank upwards and it will pop into indentation fully tighten nut

Merci

Got to love this forum..