Club 80-90 Forums

Now the bus is on the road and running again I'm finding a few bits and pieces need attention probably caused by the bus being laid up nearly 2 years ie leaky exhaust manifold joint etc, whilst underneath I noticed a coolant drip, traced it to the small pipe that is clipped around the bulkhead and around the engine bay with T,s branching off to various parts of the system , checked vw heritage and seems to be around 92 quid for a replacement , so I'm wondering if there's any good reason why I couldn't make my own in copper micro bore and solder in the relevant T pieces, any thoughts from more experienced peeps much appreciated

easy enough to make .get to it
mm

Thanks mike thought that may be the case regards

Some members were talking about making one from t pieces and rubber pipe

I'd braze one up personaly and add a reverse flare to the ends to help secure the hoses
mm

Or buy an 'as new' formerly appreciated plastic one ...

send me a PM if you're interested.

Ian