Page 1 of 1
I pushed it and it went all floppy!
Posted: 01 Jul 2013, 09:30
by Walrus
I've yet to measure which size lever it is, but even if it needs the ball joint swapping, is it really as simple as unbolt the old one and bolt in a new one? Details in the manuals (Haynes & Bentley) are a bit vague.
Re: I pushed it and it went all floppy!
Posted: 01 Jul 2013, 19:37
by Aidan
simples 14mm new solid shaft from brickwerks. 4 nuts and 1 bolt/nut from below, easy with a drop down syncro wheel carrier
Re: I pushed it and it went all floppy!
Posted: 01 Jul 2013, 23:03
by Walrus
Ordered tonight, and it's a nice weekend forecast for fitting Saturday.
Re: I pushed it and it went all floppy!
Posted: 06 Jul 2013, 12:52
by Walrus
Fitted this morning and its great - it seems to have fixed the sloppy gear change I've been experiencing for some time
which means it had been bending / getting ready to break for some time too! All nice and precise again, just like when I bought it.
As a bonus, I just thought I'd test whether the MT spare would fit - and it does! It's tight, but it clears the steering rod-thing by about 3-4 mm. At least it gets the spare out of the back, but I'll still be looking to get the rear-mounted spare wheel carrier - I can think of other uses for that space in front.