Page 1 of 1
pdsit carburettor cross bar
Posted: 30 Jun 2013, 21:35
by tamson
Hi, can anyone tell me if there is some sort of bushing that fits inside the right end of the cross bar between the spring and cross bar bracket? I think i am missing said part from my cross bar as there is a lot of play in the ball joint connection with the mounting bracket which is making it impossible to sync the carbs. Thanks
Re: pdsit carburettor cross bar
Posted: 01 Jul 2013, 10:43
by faggie
there should be a spring and a plastic bush
Re: pdsit carburettor cross bar
Posted: 01 Jul 2013, 14:02
by tamson
Hi cheers for reply. You know what im going to ask now dont you: do you have any idea what any of the sizes for it are so I can try and make one? Cheers
Re: pdsit carburettor cross bar
Posted: 01 Jul 2013, 16:57
by faggie
from what i can remember its about 15/ 20mm in depth and its dished in so the ball of the linkage sits into it and are made of a white nylon , are they not available new from heritage or gunzl
Re: pdsit carburettor cross bar
Posted: 01 Jul 2013, 22:59
by tamson
Ill check it out. I managed to come up with a fix but would prefer the proper part. Cross bar works spot on now however and there is very little play in the connection. Ive managed to get them balanced at idle and 3000 rpm.