Page 1 of 1
Fitting T3 PAS to a Subaru engine?
Posted: 18 Jun 2013, 12:27
by KarlT
Hi.
Has anyone managed to fit their original VW T3 PAS pump to their new Subaru engine? Are there any conversion mounts/pulleys available?
Cheers m' hearties!
Re: Fitting T3 PAS to a Subaru engine?
Posted: 18 Jun 2013, 13:16
by Oldiebut goodie
Wimp!
Re: Fitting T3 PAS to a Subaru engine?
Posted: 18 Jun 2013, 13:29
by KarlT
"Come 'ere an say dat!"
Once you've had it, one does get used to the finer things in life!
Re: Fitting T3 PAS to a Subaru engine?
Posted: 18 Jun 2013, 20:22
by syncroandy
Just use the Subaru pump and adapt/replace the lines as required.
Re: Fitting T3 PAS to a Subaru engine?
Posted: 18 Jun 2013, 22:01
by KarlT
Exhaust uses that mount, plus as you say new longer hoses required. Where would I even think about getting them from?
Re: Fitting T3 PAS to a Subaru engine?
Posted: 18 Jun 2013, 23:45
by Allanw
I used the Subaru pump, and the VW line that has the baffles in. A Hydraulic shop (does diggers and stuff) made up the adapters/hoses to fit it all in.
Then what I did, was fill the system... and hadn't tightened the join half way up the van, to my dirt floor in the barn is a LOT less dusty
I also made the subaru pump quite noisy, because it got a lot of air in it. Still... just sounds super charged now
Re: Fitting T3 PAS to a Subaru engine?
Posted: 07 Sep 2013, 11:58
by andy1300gt
Just fit electric power steering.....easy
