Page 1 of 1
flame spraying
Posted: 17 Jun 2013, 20:29
by scottbott
just been looking at the vanshack website and have been looking at flame spraying,filling in holes in panels,anyone had it done?,of so what was it like?,looks good to me but I am no expert in these matters
Re: flame spraying
Posted: 17 Jun 2013, 21:49
by Plasticman
Like any other methoid ,unless you remove the rust/rot it will return, in this instance around the periphery of the coat, when i lead stuff the same would happen so you sandblast cut whatever to remove it, no other way,no shortcut
mm