Page 1 of 1

What can I do about sloppy locks

Posted: 07 Jun 2013, 22:48
by badgerfax
My drivers door lock is pretty sloppy, the passenger lock isn't too bad. The slider lock does not work at all and has to be operated from inside & the tailgate is on a separate key and is like stirring porridge.

Ideally i'd like 1 key to do all the locks but am ok with leaving the ignition alone.

I have read about retumbling but not sure that would sort out the sloppiness. Do I need a new set of locks then retumble to 1 new key :?:

Any ideas

Came across this page on my travels
http://www.hallvw.clara.net/lockpart.htm" onclick="window.open(this.href);return false;

Re: What can I do about sloppy locks

Posted: 08 Jun 2013, 07:10
by Plasticman
its the part the lock internals register to that is ally and wears over time so sorting the key issues will have no effect on this, get a new set s/hand may also be sloppy or dig d££p
mm

Re: What can I do about sloppy locks

Posted: 08 Jun 2013, 13:57
by CovKid
You need a new lock, then change tumblers in it to suit your key. In most cases this only applies to drivers door which gets most wear.

Re: What can I do about sloppy locks

Posted: 22 Jun 2013, 20:49
by skippymoss
My driver door lock is a bit sloppy.
I have decided to always let myself in through the passenger side.
That way I will gradually even up the wear on the locks (and the floor mats)
Only 22 more years to go until I start letting myself in through the slider...