Club 80-90 Forums

Hi apologies if this has been covered before but does anybody know of an alternative indicator stalk most likely in the vw/audi range that will fit a T25 and has a proper headlight flasher i.e. pull to flash headlights,push to change to full beam like "normal" cars/vans have instead of trying to gauge the spring pressure without actually switching headlights fully over.Cheers bob

Sounds like yours isn't working properly - just source a new one the same or repair your current one. Yours isn't working normally compared to mine.

Thanks for the quick reply oldiebut goodie so my indicator "should" pull to flash and push to change to main beam and it's just passed the MOT 2 weeks ago.Best regards bob

Mine has the two differing degrees of pull but for flashing it is very light pressure and a lot of pressure to get the click to dip/main beam. Maybe you have lost a spring as it shouldn't be difficult to easily differentiate between the two positions.
You don't need a headlight flasher on vehicles anyway - flashers are for the park or down by the canal!

Maybe it's a combination of podgy fingers and old age but I'm struggling with flashing so i'll get my engineers head on and think of the solution,don't watch this space it could take a while.Thanks again and take care not to fall in the canal.Bob

I suffer from arthritis in every joint and I don't have any trouble but as for flashing I can't get the buttons undone quick enough!