Club 80-90 Forums

Took the buddy seat out of the Autohomes Komet yesterday to free up some space. Once the rails were removed I have 4 small holes in the floor, through the carpet.

Was gonna put smaller bolts back with some sealant but looks bit pants and kids would probably keep catching them on shoes etc.

Anyone solved this another way? Anyone seen some sort of rubber bung arrangement?

Cheers,

JW

Can't see any reason why you wouldn't be able to use bungs if you are going to be refitting it?
Cheers dazz

or fit some countersunk screws through .and well greased on the underside so the nuts dont rust up, (or SS)
mm

Be careful with the front right hole. It's right above the fuel tank. Don't drill or use a long screw/bolt, especially if the top of the tank's rusty!

Sorry to butt in,but how does the seat slide off the runners?iv got a kamper but can't see how they come off,thanks

Autostart

If you mean the buddy seat then I removed it by unbolting it from the runners rather than sliding it off. Then had to unbolt the runners from the floor.