Page 1 of 1
fitting a passat engine
Posted: 27 May 2013, 08:39
by pete-binni
been offerd a yreg passat tdi told its a 130bhp its all running and complete what would i need to fit it would my turbo diesel parts off my engine work mounts ect and what wireing would i need to do ????
Re: fitting a passat engine
Posted: 27 May 2013, 09:32
by CovKid
This really belongs in 'Alternative Engines' forum
Re: fitting a passat engine
Posted: 27 May 2013, 20:47
by syncroandy
None of the JX bits are any use to you. Would have to be fitted upright with adapter plate or using $$ kit from the US. ECU will use can-bus so you'd have incorporate the clocks. All doable if you have the time/money.
Re: fitting a passat engine
Posted: 27 May 2013, 21:13
by pete-binni
ok that is what i am looking for think a aaz is the way forward i dont have the time to pi$$ about as got a splitscreen and a heinkel to do as well
Re: fitting a passat engine
Posted: 31 May 2013, 21:34
by max and caddy
Bomber or car?
Re: fitting a passat engine
Posted: 02 Jun 2013, 17:38
by si&helen cali89
do you know the engine code of the donor if its a afn it can be done as i have one in my bus same engine in passat and audi a4
Re: fitting a passat engine
Posted: 02 Jun 2013, 20:38
by Oldiebut goodie
AFN is a lot lower on horses than 130 I believe. 110ish?
Re: fitting a passat engine
Posted: 03 Jun 2013, 18:23
by si&helen cali89
it might have been remapped to 130
Re: fitting a passat engine
Posted: 03 Jun 2013, 18:53
by Oldiebut goodie
In which case a boy racer has had it and it will be scrap.
Re: fitting a passat engine
Posted: 03 Jun 2013, 19:30
by trucker