Page 1 of 1

van still running after i took key out

Posted: 11 May 2013, 15:13
by dave lfc
earlier i had a buzzing/clicking noise coming from the 19 relay for the window wipers so i replaced this and was working fine so thought nothing of it.just got in the van and noticed the battery light was on and the flashing coolant/temp light was flashing.so started the van and they went off,turned off and took the key out and the van was still running :shock: put the key back in turned it as if to start it then turned it back off and the engine stopped any ideas what could have caused this.cheers dave :ok oh and its a 1.9 dg petrol engine

Re: van still running after i took key out

Posted: 11 May 2013, 19:48
by Plasticman
perpetual motion, your rich :rofl
sorry dont like lecky
mm

Re: van still running after i took key out

Posted: 11 May 2013, 20:03
by Ralf85
Knackered ignition switch? Mine did similar things just before it failed. Anybody else have other thoughts?
:)

Re: van still running after i took key out

Posted: 12 May 2013, 17:33
by vanisveryrusty
Ignition switch problem.
Mine did that the other way around.
Sometimes failed to start.
New switch from JK about £8, half an hours work and its fine.
There is a good link on Youtube on how to fit ignition switch.
http://www.youtube.com/watch?v=kgAxneoWejI" onclick="window.open(this.href);return false;

Got me through it

Re: van still running after i took key out

Posted: 13 May 2013, 07:11
by bigherb
Also check the windscreen is not leaking water into the fusebox.

Re: van still running after i took key out

Posted: 13 May 2013, 08:45
by slowcoach
Had this too. Another vote for ignition switch. .

Re: van still running after i took key out

Posted: 13 May 2013, 08:52
by KINGPRAWN
Ign switch... Not expensive and not too diff to do... You will need the wiki help though as you need to drill a hole

Re: van still running after i took key out

Posted: 13 May 2013, 09:53
by vanisveryrusty
No hole needed to drill anywhere when I did mine. :?
Switch is different from barrel and lock replacement.
I think thats the bit that needs a hole drilled.
The plastic ign switch just needs a small screw removing.

Re: van still running after i took key out

Posted: 14 May 2013, 06:54
by dave lfc
thyanks for that everyone,cheers dave :ok