Club 80-90 Forums

hi, are the radiator side cards still available anywhere, only seem to have a few soggy bits left. If not maybe somebody could please send me some pics so i can make some, cheers. wozza.

I thought Brickwerks did them, but I can't see them on the web site.

I could do with one too...

I made some duplicates out of flexible plastic

yep, i could do the same, but it would be easier if i had something to make a pattern out of.

bottom rad card found at brickwerks and ordered

well replaced my rad today ( from B'werks) and I was going to ask if anybody knew where to get the card, didn't see that on B'werks so thanks.

looks to me like you could just make the other two from the lower one it's almost enough card and at £4.30 x 3 worth a go.

Mine are in tact but looking very tired, wozza825y I will get a pic up so you can see what they look like.

http://www.brickwerks.co.uk/index.php/c ... lower.html" onclick="window.open(this.href);return false;

cheers in advance itchyfeet

OK so I found a piece of 1mm thick dark grey plastic in the shed today and made some

Plastic was a felt support tray like this, probably get a single somewhere.
http://www.screwfix.com/p/felt-support- ... tid=156974" onclick="window.open(this.href);return false;

Yet to see if they will take the heat, I poured boiling water on the plastic and it was bendy but I doubt they will get to 100 deg if they do I'll make some more out of something else.

They are the same profile each side but one side has a hole cut for the rad fan switch, I was concerned about plastic rubbing on the wires so I added some sleeve.

The cards are bent opposite ways each side and set at 50 degree on the main bend by a strap, I used a cable tie on the ones I made as it's easier.

there is a cutout by the grill which has no use on mine so I left it out of one of the cards to make it stronger.

the all important dimensions....

great stuff, just the job.