Club 80-90 Forums

Aidan passed me a NOS pair of these lower alloy spacers to get quoted at the Foundry rather a long time ago They've been a bit "lost and found" but are now on my desk again and about to hit the post, to get quoted for a small batch.

They have a proper pigtail seating top and bottom, are tapered to help correct the spring seating angle and measure from ~11 to 17mm thick, so give a nominal 14mm lift.

I'm guessing at asking for 10 or 20 pairs, assuming they're not back on catalogue at Classic now, in which case I'll just post them back to Llanfyllin.

What's the level of interest, uf any?

I would be interested,price pending.

Yup

The ones on my pickup are still usable but may not be in five years, so I'd be interested in a spare set, so long as the syncro-scene-tax is zero-rated

Hotpod has got my set and was getting some made, might be worth sending him a pm and work something out between you. No point two of you making them.
(just so your aware, i'm making no money on the copies of mine. So have no vested interest on who makes them..)

Guaranteed zero syncro scene tax rated Andy. They'll cost what they cost. I'll get them away for a swift quote and get straight back. Too much of this stuff hanging about, got to get a load of it moving.

I'm not fussed if I organize the repro of them or not, as there's not much in it for me either. I don't want a pile of them sat on the shelf for years!

silverbullet wrote: I don't want a pile of them sat on the shelf for years!

thats what i meant by pming hotpod, only needs one of you to make them