Club 80-90 Forums

Hi All,

I'm going to check my pump timing when I do the cambelt. I have a Dial Gauge for doing lathe work. What I was wandering is can I make a rod up do the timing and if so how?

What dimensions will I need?

I can give you the dimensions,i assume you can cut threds on the lathe?

dave friday wrote:I can give you the dimensions,i assume you can cut threds on the lathe?

Thank you very much for the offer, and yes could cut threads but have bought this from ebay,

http://www.ebay.co.uk/itm/US-PRO-VW-3-1 ... 6216042%26

Would love to have had time to make something but you know how it goes.