Page 1 of 1
T3 Bluestar R&R bed/seat
Posted: 06 Feb 2013, 15:30
by flying haggis
Hi all I've just managed to get a original bluestar bed for my bus only I've not a scooby on where all the brackets go.
So I'm after a few pics if possible of where the seatbelts are mounted and where its bolted down etc
Any help would be magic.Cheers
Re: T3 Bluestar R&R bed/seat
Posted: 06 Feb 2013, 18:14
by gtavalanche
What van are you putting it in? Do you have the pins, spacers and brackets?
Panel van= You need to have the brackets welded in the correct position, then you need the square spacer blocks. Screw pins in. Jobs done.
Caravelle= You can either move the brackets you have then swap pins, make an adaptor up between the existing brackets and wear the back of the seat should be.
The thread with the pics I used for reference is no longer available. But I'll try dig out some pics.
Re: T3 Bluestar R&R bed/seat
Posted: 06 Feb 2013, 18:29
by gtavalanche
Re: T3 Bluestar R&R bed/seat
Posted: 06 Feb 2013, 18:42
by ZsZ
Some pictures of my install:
http://www.vwt3.hu/pic081217
http://www.vwt3.hu/pic090404
the red one was the donor bus
Re: T3 Bluestar R&R bed/seat
Posted: 06 Feb 2013, 20:48
by flying haggis
Bob on guys I should of mentioned its a panel van convert,I've got the spacer blocks and the seatbelts I was just stuck on where everything went
Il get the brackets made and in but that's after the mot work and the respray lol