Page 1 of 1
Access to Heater fan
Posted: 12 Jan 2013, 12:18
by chrispow01
OMG, how hard is it to get to the fan. Ive got the dash off and exposed the heating and ventilation unit (thanks to Wiki) but i'm struggling to split the unit to expose the fan. There are no clips on the model i have, it seems to be pressed and glued together. I'm panicking im going to break something by prising it. If any one has done this, any tips would be most welcome.
Re: Access to Heater fan
Posted: 12 Jan 2013, 12:22
by nicq
Mine was had to separate all round with a Stanley knife.
Good luck
Nic
Re: Access to Heater fan
Posted: 12 Jan 2013, 13:48
by dumbo
hi sounds the same as mine one .....done it last year.... used stanley knife and wall scraper to spilt into it.... but take your time its on the forum good luck
Re: Access to Heater fan
Posted: 13 Jan 2013, 18:46
by chrispow01
Stanley knife it is, thanks chaps!
Re: Access to Heater fan
Posted: 13 Jan 2013, 18:53
by Reimotim
Stanley blade does the job, take your time and go steady!
Also worth ordering the 11 clips you need to put it back together in advance so you have them by the time you need em.
Re: Access to Heater fan
Posted: 15 Jan 2013, 17:53
by chrispow01
Well took a bit of coaxing and a few swear words were uttered but did manage to split the unit and get access to the heater which was indeed kaput. New one ordered and looking at the mess that is now the dashboard, cant say i'm looking forward to re-assembling. On the plus side, i have learnt a fair bit about the van..Thanks again for the tips...
Re: Access to Heater fan
Posted: 15 Jan 2013, 20:22
by nicq
When I did mine it went back together much easier than taking it to bits. I think I was trying so hard to remember how it was put together that it took longer than it should have. I glued my heater back together as I wanted to get it done the same day, I had already bought the fan.
Good luck
Nic