Club 80-90 Forums

Does anyone know where I can buy a new flywheel for me 1.9dg, cant find one anywhere

are dg/df the same ?
mm

Not sure, can you get df ones then?

crump167 wrote:Not sure, can you get df ones then?

DF are 215mm diameter along with early DG, late(r) DG and 2.1 DJ/SS/MV are 228 mm.

Ian

they are actually mixed.

you just need to know the clutch size as above 215 or 228, but it dosent matter if your buying a new clutch as well.

they also do ones with the ring gear either cast into the flywheel ( poss 2.0 Aircooled) and ones with a seperate ring gear. but they all seem to fit df, dg , dj , cu

you may not find a 'new ' one . whats wrong with yours ? i may have a good used 228?

Mine is a 228, keeps tearing the face off the oil seal, after 3 times and much research came to conclusion needed to get flywheel re faced, after getting quotes thought might aswell buy a new one

no longer available in europe new so a good used one is as good as it gets

Thanks, looks like a trip to the machine shop.

crump167 wrote:Mine is a 228, keeps tearing the face off the oil seal, after 3 times and much research came to conclusion needed to get flywheel re faced, after getting quotes thought might aswell buy a new one

Don't quite understand how the face of the flywheel will tear the oil seal....

I dont get it either, the lip comes away from the outer ring, cant explain any better

if the seal surface of the flywheel is damaged then I'd be looking at a SpeediSleeve solution rather than machining as the seal is only available in one size - are you using genuine seal or aftermarket, and how much end float have you got ?

Checked end float is good, not sure what a sleeve is, be grateful for more info, ta

love to see a picky of this bit
mm

Will put pic on asap mate, might help sort out whats going on with it

yes also the seal insitu and maybe out as well and the old ones you kept?
mm