Club 80-90 Forums

I am wanting to remove my heater. Can anyone give me any tips or advice on doing this.

Cheers

Have you read the Wiki?

Not about removal no

This is of no help?

"Before starting work take the earth strap off both the main and leisure battery. This is not strictly necessary but is a sensible precaution before doing any major work on your van. To remove your eber you need to do the following. Start by removing the “Black buzzing box” and the shelf it sits on underneath the bench. You should then have access to the main eber control unit and wiring. Unclip the control unit and pull the electrical plug out of the bottom. Then undo any other electrical connections so the cable that runs down the air inlet is free.

Next climb underneath the van and undo the combustion air pipe, the exhaust and the fuel line from the inside edge of the eber. On the back side of the eber the air inlet and hot air exhaust pipes should be removed. After that the 4 blots holding the eber to the chassis can be removed. Be careful of the little rubber vibration dampers as they can break easily if not handled with care. If you do break one it is possible to glue it with a good expoxy glue as they operate in compression, not tension. With those bolts off the eber can be removed from the van.

The Eber casing can be removed by undoing the million or so little screws around the centre line where the casing join can be seen. At this point my memory is a little hazy so the best thing before taking anything apart is to pause and take a mental (or real) picture of how everything looks and fits together. Once you get the outer shell and inner shell off you should be able to see all the components from page 13 of the eber manual in front of you."

Thanks very much for all that mate!

That's in the Wiki!