Page 1 of 1

NOT FEELING THE ROCK & ROLL!? HELP!!

Posted: 28 Aug 2012, 19:45
by shrekwoody
hi people anyone out there got any good advice on fitting rock roll bed to my t25 :roll:

ive purchased old devon metal framed rock roll bed frame and just trying to suss how things quite fit :run

am i right saying when laying in bed position the bed is higher than engine bay floor and im asumeing ive got to build to it/support it

carnt quite work out the bracket ends that face rear bulkhead, do i have to fix sum kinda bracket to secure it to van?

am i also rite that the base frame of bed should run level with the start of door opening, mines a twin slider

any help advce tips how to fit will be great thanks :ok

Re: NOT FEELING THE ROCK & ROLL!? HELP!!

Posted: 28 Aug 2012, 19:57
by billy739
with some metal framed ones , as used in bay windows you are correct in the bed being higher than the rear floor when in bed position .


i am sure it the devon type, as devons had draws/storage under the bed.


others including westy ones had no draws so were at deck height when down.

Re: NOT FEELING THE ROCK & ROLL!? HELP!!

Posted: 28 Aug 2012, 20:24
by shrekwoody
arrrh that makes sense!! yes...storage room, just googled sum pics too and that helps

thanks for the help :ok

Re: NOT FEELING THE ROCK & ROLL!? HELP!!

Posted: 28 Aug 2012, 20:39
by 82JEW75
Devons had a plastic moulding that lived under the rear cushion (over the engine lid), storage for the table and leg.