Club 80-90 Forums

Hi I am on the look out for a replacement inlet manifold for my 1600 ct air cooled engine.
It's rusted through on the exhaust pre heater.
Currently has a coke can and a load of exhaust Paste rapped round it
my question is would an earlier manifold from say a 1600 bay window fit?
Any advice would be grate Thanks Jamie.

Bay inlet manifold won't fit I'm afraid.

Normal solution is to cut and weld them.

Thanks for the advice
Looks like i better get the mig welder out agen only just put it away after getting the van sorted for the mot Ha Ha!