Club 80-90 Forums

Anyone fitted anything else to the steering cowling where the heated seat switch is meant to be?

Temp gauge, voltmeter?????

If so what did you fit and where did you get it please

Size is 40mm x 25mm

Hi Cruz,

I have inserted a temperature gauge in mine like this:-

http://www.ebay.co.uk/itm/Digital-Therm ... 4aa602f816" onclick="window.open(this.href);return false;

It requires a bit of filing to fit but it goes in ok, then just routed the sensor to the outside via the door shut.

Works fine and is as cheap as chips, just like a posh car now.

Hope this helps, Mark.

Just the job

Did you wire it up to the ignition?

Looks like it can only be powered by the two button batteries Cruz.

http://www.ebay.co.uk/itm/LCD-DC-12V-Di ... 35b7d5274c" onclick="window.open(this.href);return false;

this one has either 12v or battery ??

Thats just the ticket. Well for what I was after anyway

James,

That one does not look like it will fit in the hole, its too big, the other tiny one only fits with some adjustment with the scalpel!

There isn't a lot of space in there to work with.

Cruz,

Here is a picture of how mine looks:-



It only gives a guide to the temps really but it is fun all the same. Until the batteries go flat anyway, but they are so cheap just buy a couple.

Cheers, Mark.

I have the one that James linked to on the dash already

The temp may not be enitrely accurate marcus but it's better than an empty hole

Hi Cruz, would it be possible for you to put up a pic or two of your gauge in situ please? I'd like to see it as I'm rather taken by neat little additions like this. Cheers.

It's just the same as the picture above

ok, ta very much.