Club 80-90 Forums

Posted: **31 May 2012, 20:12**

got a knackered rubber mount at the offside rear.....advice warnings etc appreciated

Posted: **31 May 2012, 20:14**

What engine?

Posted: **31 May 2012, 21:34**

If it's the same as your garage van then I would be changing all four..
might as well as they come in a set

support the engine safely and follow the haynes

Posted: **31 May 2012, 21:55**

changed mine this week... quite easy, but buy from brickwerks.I tried to save a few pounds and bout some 'German made' ones from ebay. The inner mounts wouldnt fit

So had to order another set from Brickwerks, went straight in no bother.

I took the engine support bar off and the cradle that holds the 4 mounts, not sure if the manual suggests doing this but it looked the easiest option

Posted: **31 May 2012, 22:04**

sorry mines a 2 litre Aircooled gas guzzling lump !

Posted: **31 May 2012, 23:34**

still easy to do but you need to remove the alloy cooling shroud , fan , and alternator to get access to the mounts but can be done without dropping the engine from the gearbox just remove gear linkage and lower engine down enough to gain access under the rear valance

Posted: **01 Jun 2012, 06:21**

banjax34 wrote:sorry mines a 2 litre Aircooled gas guzzling lump !

please put your engine type in your signature then...
No crystal ball gazers here.

Posted: **01 Jun 2012, 22:22**

is that ok ?

Club 80-90 Forums

engine rubber mounts.......easy job ?

engine rubber mounts.......easy job ?

Re: engine rubber mounts.......easy job ?

Re: engine rubber mounts.......easy job ?

Re: engine rubber mounts.......easy job ?

Re: engine rubber mounts.......easy job ?

Re: engine rubber mounts.......easy job ?

Re: engine rubber mounts.......easy job ?

Re: engine rubber mounts.......easy job ?