Page 1 of 1

Centre bottom of dash

Posted: 19 May 2012, 21:05
by James.rigby
Hi all how does the heater vents next to the glove box attatch to the bulkhead/dash?? Cheers jim

Re: Centre bottom of dash

Posted: 19 May 2012, 21:15
by Plasticman
push fit , there are iirc 2 small lugs on the top and 2 on the bottom , ducting at rear is pushed on over simmilar 'protrusions' :lol:
mm

Re: Centre bottom of dash

Posted: 19 May 2012, 22:05
by James.rigby
Don't think I have any mate are they part of the dash or centre ducting. Could you get a pic for me? Cheers

Re: Centre bottom of dash

Posted: 19 May 2012, 22:10
by Plasticman
Ah you mean the triangularish shaped bit that is behind the gear stick and under the dash, if so then hand eitherside , fingers at the back , thumbs on the front face and press in with thumbs and sort of curve it and it will pop off..fwd
mm

Re: Centre bottom of dash

Posted: 19 May 2012, 22:30
by James.rigby
But what does it press into mike? Lol :?

Re: Centre bottom of dash

Posted: 19 May 2012, 22:38
by Bilson
James.rigby wrote:But what does it press into mike? Lol :?

Are you wanting to keep it in place rather than remove it? if so, I've got the same problem!

Re: Centre bottom of dash

Posted: 19 May 2012, 22:40
by Plasticman
lugs as such on the heater unit
mm

Re: Centre bottom of dash

Posted: 02 Jul 2012, 20:02
by James.rigby
What if I have no heater unit lol

Re: Centre bottom of dash

Posted: 02 Jul 2012, 20:19
by kevtherev
What colour is it?

Re: Centre bottom of dash

Posted: 03 Jul 2012, 20:15
by James.rigby
Black kev it has the vents on the side of the unit. Want a pic?

Re: Centre bottom of dash

Posted: 04 Jul 2012, 12:36
by Dazco
metalmick8y wrote:lugs as such on the heater unit
mm

as MM says, but they do have a tendancy to break off, i had to hot melt a couple back in place on mine that were just about to snap off

Re: Centre bottom of dash

Posted: 04 Jul 2012, 13:20
by James.rigby
I've past that daz they gone. Never to be seen again lol