Club 80-90 Forums

I am sure mine is held on with two screws ,I had a look on e bay for a replacement and I can see no screws?

and if I am not completly going bonkers, can you just change the mirror bit to go on the arm?

The rear view mirror has no screws. It is a press fit and can be twisted up and out (or down and out )

Rear view mirror? Dunno if mine's different to CovKids but you twist it through approx 45 degrees (clockwise I think) and then it drops/pulls out.

No definatly has two philips cross threads...Looks totally stock...

yes rear view mirror..

I concur. There are NO screws holding on the original rear view mirror

06.44 am to take a picture in the cold and wet... I hope you can see the screws...



The back of the mirror has disintergrated [?] when I grabbed it...

Nobody was doubting the existence of the screws. Just that you will not find another T3 rear view mirror that is fixed with screws unless, like yours, they have been added by a previous owner

I`ve took it off and found there is no depression to click the stock one into ,I can take a picture ...

maybe some buses had a different arrangement...?

silence...

Well there would be, wouldn't there. Yours is not stock (well I've never seen one like that) so we have nothing to compare to I'm afraid. You sure it doesn't have Transit written on the back?

Heck, the dictionary on 80/90 is irritating sometimes, makes my post look more derogatory

T.R.A.N.S.I.T

just looked at the back of the screws ,someone has angle grinded the lug off ,mmm i guess I will have to do the same...

dandaz wrote:I`ve took it off and found there is no depression to click the stock one into ,I can take a picture ...

maybe some buses had a different arrangement...?

Some buses are bodged by previous owners, as I am sure they didn't make one special one