Club 80-90 Forums

Hi Everyone,

Coming up to MOT time and looking to sort my exhaust prior to this. The silencer and the question mark shaped pipe prior to the silencer have small holes in them and i want to replace these parts. after a bit of looking round ive noticed that my exhaust has a sraight piece of pipe between the silencer and the 90 deg bent pipe with a tapping for a sensor in (lambda i'm thinking) Ive noticed the replacements ive seen dont have this pipe. I'm not sure but i think its specific to the SS engine. Has anyone any idea where i might source the parts from or a workaround for this. Many thanks in advance

http://www.brickwerks.co.uk/shop?page=s ... ory_id=103



Ian

yes, Brickwerks.
i have one and its pretty good.
you can buy just the bits you need now,rather than buying the whole system, as every part is a direct replacement to the original mild steel one.

the only bit that isnt SS is the "knuckle" joint .

do it once and forget about it.

Thanks guys, Looks like a stainless one it is then!