Club 80-90 Forums

hi everyone im in the process of changing the cupboard units in my van and i have a propex to fit , i read that someone had mounted theirs on the sloping panel under the bed what i was wondering is do i route the exhaust and inlet pipes seperate ways (one to the n/s and the other to the o/s) and wouldnt they be a bit close to the engine ? if anyone has any pics id be very grateful cheers jeff

Mine is on the floor under the bed, not the sloping panel.....Don't have any photos though sorry

I think 'kevtherev's is mounted on the sloping edge under the seat. I'd find a picture but there's so many pictures of kev's van on the club website I'd be looking till next wednesday

thanks lads

Mines on the sloping bit, offset towards the sliding door a bit, and the exhaust protrudes nicely just infront of the jacking point, with the intake pointing in the opposite direction. Hot air duct is out of centre of the front panel of the R&R bed/seat.

Mines on the flat under the rock and roll