Club 80-90 Forums

R0B wrote:Just rip it off and bin it.The fewer of those body kits in the world the better. You will be doing the t3/t25 world.A huge favour

£350!!! Thats a bloody propex heater

£350 It just goes to show what they say about a fool and his money.Is true.

Makes them look like those Dodgems they have at the fairground !

You need some propr spots 6 and 3/4 or 7" for the grille to look right. Hella were the originals, but Ring also supply them.

Update on the bodykit:



What a bloody nightmare

I ended up having to blowtorch my heavy duty scraper I bought till red hot then slap down the rear of the body kit panels to push through the adhesive. All off now and on ebay anyway.

I am glad I did it though as was hiding a multitude of sins:





Luckily non into the sill though. Anyway that's for another thread

BMB

She looks better already without the bodykit!

Can someone advise. Is that line meant to be on the lower panel? Or has this been repaired before?

I thought this panel should have a seem along the top? Not sure how best to replace now.

yep thats the sill

thats how it was meant to be, I fear you will find much fishing bait behind that lot when you investigate as thoroughly as im sure you will.
mm

Ah I thought the sill was the structural part inside, I guess that's the inner sill?

So given the inside is generally OK and the panel is fine from the sill seam upward:





Do I just need to buy an outer sill? All the guides on here seem to replace with a side panel that has the sill and lower panel in one?



Is it possible to get access the the upper lip to weld if only replacing the sill?

Thanks