Page 2 of 2
Posted: 27 Jun 2006, 22:13
by HarryMann
They're £25 each at GSF with a bit of discount..
If you don't change the outers as they feel OK and don't , then at least get the grease back around the joint by squeezing the boot.
Wki on CVJ internals
http://www.club80-90.co.uk/wiki/index.p ... nts_repair
Wiiki on Brakes...
http://www.club80-90.co.uk/wiki/index.p ... _Backplate
http://www.club80-90.co.uk/wiki/index.p ... _servicing
Posted: 01 Jul 2006, 12:51
by trikey
Cheers for all the advice, i have now fitted the driveshaft oil seal, four CV gaiters and new pads and shoes and theres noway that i could of done it without the help of this forum, just need to keep an eye out now for that 1.9 D engine and i`ll be sorted,
cheers all
Sean
Posted: 31 Jul 2006, 19:38
by cooky73
can this job be done without removing the other end of the driveshaft from the hub etc. ???
Posted: 31 Jul 2006, 19:46
by HarryMann
Yes
Posted: 01 Aug 2006, 08:29
by cooky73
nice one - can't see the driveshaft oil seals in gsf or euro though - are they a dealer only part?
jk don't seem to have them in the catalogue either?
Posted: 01 Aug 2006, 09:35
by HarryMann
VW
091 301 189 (Seal)
002 301 185A (Ring) - Not sure if you'd need this part, but its listed as part of a repair kit..
Anyone?
Posted: 01 Aug 2006, 09:49
by cooky73
Nice one - will go to the $tealers now
Posted: 01 Aug 2006, 13:34
by cooky73
they are ordering the bits from Germany
20 quid for both - seems ok!
Posted: 01 Aug 2006, 16:23
by HarryMann
Good, they might realise sooner or later that thse are bist that should be in stock at MK