Club 80-90 Forums

keep it clean! remove all paint and rust from the area you are welding. cut the metal back away from the rusted area and remove the paint. as tony says practice on some clean sheet to start with, use this to set up your welder than tackle the bus. i found mig easier than arc, so keep trying, let us know how you get on tomorrow

That's the problem i had at the weekend, no metal to weld to. I had to rebuild a pillar and wheel arch before i could think of putting the panel on.

great fun isnt it?

which body bits did you burn peps

On page one mate.

yeah i seen those...im ment YOUR body parts...you must have got the one that goes down ya glove and makes a new home between ya fingers...if not your doing it all wrong

Didn't burn any body parts but hands cut to ribbons

sounds like you need to employ a welders m8 to deal with those jobs

gee isnt mig weldin for the first time fun....if your havin probs setting it up duck....find a bit of scrap tin....arc up on it and turn the wire speed up and down till you get the owd bacon frazzle......being an experienced welder anyway...you shouldnt have too many probs........i personally find stick welding much harder than mig,as you are findin mig harder than arc.....with the credit crunch booming ive had to show loads a lads lately how to mig weld as theyre findin garage prices way to high....some take to it like a duck to water..some are only fit for fire watchin......im sure itll be fine owduck.............