Club 80-90 Forums

Is this really what the TDC mark on the flywheel is supposed to look like? In the pictures and videos I’ve seen, the mark always seems much clearer and more distinct. On mine, it just looks like a small radiused notch in the edge of the flywheel. Is this definitely the TDC mark?


Skickat från min iPhone med Tapatalk

Yes. On. wither side you get an upward facing not ch

Cheers, feels good to have that confirmed.

I’ll continue changing the belt tomorrow. Next up is loosening the camshaft sprocket bolt, as there was a slight discrepancy between the camshaft position and the TDC mark, as I mentioned earlier.

However, a colleague suggested that before I do that, I could fit the new belt, tension it and see if that alone brings everything back into alignment. I guess his thinking is that wear or stretching of the old belt might account for the discrepancy, and that a new, properly tensioned belt could put everything back where it should be.

Could there be any truth to that?

I wouldn’t have thought so - you might be able to use the old timing to shortcut a rough alignment but consensus seems to be that the cam sprocket should be loosened and alignment checked for it to be properly dialled in.

There’s more info in this the first page of this samba thread:

https://www.thesamba.com/vw/forum/view ... 9a5032fb7e

Loosen the camshaft bolt.

1/2 a tooth off and the belt is a bitch to fit.

The belts don't stretch. they get old which compromises the stregth. If they stretch you have valved hitting pistons. So ignore the comments of your contact.

Do NOT use the camshaft lock to lock the camshaft to remove the bolt (45nm)

You need to make a tool to hold the sprocket.

There are loads of good vids for the entire procedure on YT with older golfs that had a near on identical engine.

Mage sure you have a new tensioner.

when all buttoned up. Give the crank a couple of turns to make sure its all moving.

Crank at TDC, fuel pump at TDC then camsgaft at TDC.

If the cam is near on when getting it to TDC you can use pipe wrench to turn it a tad to get it perfect. Use it between the lifters well wrapped.

Just take your time. You got this.