Club 80-90 Forums

AngeloEvs wrote:The Tacho pins will be the same as the oil pressure DOPs and the CJ kit uses the single female connector so I would use the same for the tacho as shown in your EBAY link.

Thanks, I'll get some

To follow this up,the Dupont connectors do indeed push on fine to the tach pins, and also onto the LCD clock power pins. The wire gauge is very thin, but it does seem to take the tach signal fine and it all works.

Do you have any pics?


Sent from my iPhone using Tapatalk

did you ever take any pics.  still not done yet.

thx

I used the slaughter house custom pcb kit to replace my dash system, apart from a clock problem it was straight forward 1987 1.9 petrol