Club 80-90 Forums

Thought it might be you.ill get my son to check photos and video out .I think the butterfly flap is stuck open I'm taking carb off this afternoon to get some more opinions.

Im guessing the second choke puller has failed open

Your not in a hurry then pan al

Photos - first post in this thread

https://forum.club8090.co.uk/viewtopic. ... 7&t=162895

Second choke sticking open would have this result

At last I'm getting somewhere. Had carb off give it a goog clean and air blow.next to the vacuum unit there some levers that operate a plastic thing like a cam which opens and closes the throttle butterfly flap that had gone to far and got stuck on other side of cam for it by playing with it till something went clint and released it.popped it all back togeather and now I can get tick over but still quite lumpy.ill play around with it for a couple of days to see if any improvement before boxing it up.

Good.

No points for the garage that didn't spot that

Got the carb ticking over it was a cam next to vacuum unit underneath the carb it had gone to far and got stuck happened to release by playing about with it.ill see how it goes before boxing it up properly.

Check these pics out.

https://imgur.com/a/PZIKDTv

i embedded one of the pictures for you, the code is first with a missing [ at the front so you can see it

img]https://i.imgur.com/1tqeWIL.jpg[/img]


Looking at the video is the second choke just floating around free - I don't have Pierburg so others will know more?

That nylon part is broken at the end I think
I can only find a fuzzy photobucket image , sorry

Yours seems shorter

and therefore jumping out of the groove ??

Have a read here ......

https://club8090.co.uk/forum/viewtopic.p ... &start=180" onclick="window.open(this.href);return false;

You will learn all about carbs and fuzzy pictures!

I think you might be right I'll take some more videos and pics then we can analyse it further I was struggling taking videos.

Yep I agree. Broken tip. The leg of the white piece should come up between the metal tangs as in one of Mocki's pictures, and there was an adjustment tolerence
of, I think, 0.5 between the tangs and the tip, you could close it or open it with a pair of pliers.

Regards

Can you buy these plastic bits and if so where from.
What are they called.

pan-al wrote:Can you buy these plastic bits and if so where from.
What are they called.

If you look at the link Mocki posted they had been reproduced. Maybe worth contacting Chris(cjh) to see if has any. Or maybe Bromyard/GW.
David.