Page 2 of 2
Re: Metal fragment inside alternator – replacement?
Posted: 27 Feb 2017, 18:55
by Oldiebut goodie
Ooooerrrrr! There has been some hammering of loose metal there for some time by the look of it, surprised it didn't totally disintegrate.
Re: Metal fragment inside alternator – replacement?
Posted: 02 Mar 2017, 19:23
by johninleeds
Oooerrr indeed!
Been talking to forum member garyd who may be able to supply me with an alternator fairly cheap, but I've been looking at my alternator bracket today and think I might have a problem as the two holes are different sizes – the one furthest from the back of the vehicle (foreground in the photo below) is wider. There seems to be about a 1.5mm difference in diameter, enough that the bolt fits fairly well in the narrower one but flaps around a lot in the other. This does explain why the mounting bolt has tape on it I guess.
Could the hole have widened due to the alternator bouncing around? Or am I missing a bush of some kind? garyd's suggested this to be the case but I can't find any mention of a bush on the mounting bolt anywhere in manuals/online etc. Whether or not a bush was fitted it does seem like this would solve the problem, assuming I can get hold of one, otherwise I'm not sure I have many options beyond sourcing a new alternator bracket.
IMG_20170228_164914-.jpg
Re: Metal fragment inside alternator – replacement?
Posted: 02 Mar 2017, 20:09
by Oldiebut goodie
Oldiebut goodie wrote:The bolt is too thin for the alternator hole allowing it to tilt, someone has attempted to pad it out with that tape. Can't see why someone has drilled a separate hole though.
( I have seen some alternators that utilize a roll pin on the pivot that allows different sized bolt and bracket and tight fitment in the bracket)
Re: Metal fragment inside alternator – replacement?
Posted: 02 Mar 2017, 20:21
by johninleeds
Right, sorry!
So new bolt, swap the electrical tape for a roll pin (and the old alternator for a new) and all may be good.
Thanks.
Re: Metal fragment inside alternator – replacement?
Posted: 02 Mar 2017, 20:26
by bigherb
There should be a bush in the larger hole which slides through and allows for the slight variations in alternator mountings.
VW part number 052 903 147
Re: Metal fragment inside alternator – replacement?
Posted: 02 Mar 2017, 21:25
by johninleeds
Thanks bigherb.
Looking at a photo of that bushing, and the last photo I posted, I'm wondering if it's possible I already have that part in situ but that it's seized? If that's the case it's very very seized!
Re: Metal fragment inside alternator – replacement?
Posted: 02 Mar 2017, 21:32
by Oldiebut goodie
Had a look around and some vw models did use the roll pin version. Golf, Jetta, Passat,Polo,Scirocco.