Club 80-90 Forums

[img]http://i241.photobucket.com/albums/ff21 ... 7BDDD9.jpg[/img]

This pic seems to show it best.
Shaft is straight, pulley wheel is off.

And the washer is a 5mm thick solid slab.

So now I just need to source a new pulley, washer and bolt. I don't fancy spending 90 quid on a brand new pulley from vwheritage.

I'll try to take some more pictures of the actual pulley in the light when I get home.

Oh and it needed a 30mm socket. Only £6.49 at halfords

I will check tomorrow to see if I have a spare single pulley; if I do then there should be a bolt and washer.

silverbullet wrote:I will check tomorrow to see if I have a spare single pulley; if I do then there should be a bolt and washer.

If you do, that would be most fabulous. The camper is only in Feltham

A local one! I will post up asap, yay or nay.

Well here is the proof that the pulley is well and truly goosed. I can only assume it inadvertently took a whack as the engine was being fitted.

Aah yes, looks pretty cream crackered Jonathan.

*rummages about in used spares*

I also have a single pulley should you need it.

Pulley and correct washer, but no bolt.

Drop me a line at my works, I keep my pm's off these days. Might well be in tomorrow a.m.

PS I checked the pulley on a lathe, it's good.

silverbullet wrote:Pulley and correct washer, but no bolt.

Drop me a line at my works, I keep my pm's off these days. Might well be in tomorrow a.m.

PS I checked the pulley on a lathe, it's good.

Thanks, hope you got my email

I am not in work after all, rampant lurgi at home, troops dropping like flies

That's fine. I couldn't come til Monday anyway.

Righto. Put to one side for you.

Good to meet you today. I have put that manky chiselled bolt to better use:
[img]//uploads.tapatalk-cdn.com/2016021 ... e97074.jpg[/img]
PS I put the wonky pulley uner the press and it straightened out quite well, but it doesn't "ring" like it should; I suspect the rivets are now loose...