Club 80-90 Forums

clift_d wrote:

New Kentish Campers wrote:On a more positive note, just be thankful that you hadn't employed this shower to do a structural repair, like a chassis rail.

I'm not so sure. Aren't some of those pictures the joint between the front valence (?) and the bumper that constitutes the front crumple zone? It's difficult to tell as the images are taken so close to the van.

You could be right Could the OP perhaps put a copy of the estimate/quote up for us to see?

I hope these new panels were at least welded on, against being brazed in. when in bodge mode, who knows what's been done it's a real 'fred-in-his-shed' type job and I feel very sorry for you.

Hope you get it resolved

Not that it helps you but I did a better job myself on my first attempt.

Needs to be bare-metalled to see what on earth is going on under there
Waste of new panels, was it done by a specialist in t25s?
Looks like a diy first attempt...