Page 2 of 2
Re: Correct Ignition Coil Resistance + Mixing HT Leads
Posted: 08 Jun 2015, 19:16
by mike9009
My CU engine had the same symptoms and the ignition amp solved the issue. (Although mine got so bad I could only do about one mile before it died and needed to leave it for ten minutes before returning home!)
Mike
Re: Correct Ignition Coil Resistance + Mixing HT Leads
Posted: 08 Jun 2015, 21:06
by HarryMann
I would expect that's fixed it.. 20-30 years life seems quite common for many of the T25s electronic components.
Re: Correct Ignition Coil Resistance + Mixing HT Leads
Posted: 09 Jun 2015, 11:22
by tobydog
I would apply some thermal paste between the amplifier and heat sink.
Re: Correct Ignition Coil Resistance + Mixing HT Leads
Posted: 09 Jun 2015, 12:41
by HarryMann
Very good idea... fairly easily available in computer stores?
Or Maplin
Re: Correct Ignition Coil Resistance + Mixing HT Leads
Posted: 09 Jun 2015, 12:44
by Fudgy666
HarryMann wrote:Very good idea... fairly easily available in computer stores?
Or Maplin
Brickwerks included a small sachet in the box. But I've managed to 'borrow' a tube of Heat Sink Compound from work to add a little more
