Club 80-90 Forums

keytouch wrote:30amp maxi blade fuse on each wire

Bit high rated, p'raps?

60w @ 12v is 5A (nearer 4A at 14v with engine running). If you're running one cable per filament, I'd be going with ~10A at most.

Sorry I meant one wire per state, so 2 filaments on each wire.

So 120w draw.

Maybe I'll change them to 15 amp fuses

Brilliant mate..sounds like you have a result, those bulbs should be working somewhere close to Max and a hell of a lot brighter with 3 more volts.
I must admit, running 4mm all the way to the rear sounds epic, I' m not sure whether I would have opted to got straight to the leisure battery instead..admittedly with an upgrade to the split charge relay but then that's a wise move anyway.
The leisure would be working harder, as would the split charge relay and wiring to replenish lost charge, but then it's only 10 amps on a single lamp model so even the standard relay should cope...
Martin

It wasn't too bad, they are in a sleeve and run underneath the van attached to various points and going over the fuel tank etc,

My leisure batteries (2 x 100ah) are about 30cm from my starter battery in the bottom of my wardrobe.
I took the opportunity of running a big 6mm wire at the same time just in case I ever get round to fitting epas.

I've just been out for a drive in the dark.

Wow. I can see a hell of a lot more.

I tested the full beam, looking at it head on was like looking at the sun! I just had complete white-out in my vision

Fit marine terminal blocks and forget measuring voltage drops altogether:

https://club8090.co.uk/wiki/VW ... ry_to_dash" onclick="window.open(this.href);return false;