Page 2 of 2
Re: Front brake disc splash plate
Posted: 15 Jul 2014, 17:39
by xpress
That's a dinner plate! There's a space for my peas chips and ketchup!
Nope that's the one! Gonna fit it!
Re: Front brake disc splash plate
Posted: 06 Mar 2015, 19:32
by garrytheskate
I have a splash plate missing. I am getting a replacement and need to know the size and length of the three Philips? head screws that hold It on
Thanks
Re: Front brake disc splash plate
Posted: 06 Mar 2015, 21:18
by bigherb
garrytheskate wrote:I have a splash plate missing. I am getting a replacement and need to know the size and length of the three Philips? head screws that hold It on
Thanks
M6x12mm
Re: Front brake disc splash plate
Posted: 07 Mar 2015, 09:17
by garrytheskate
Many thanks
Re: Front brake disc splash plate
Posted: 07 Mar 2015, 12:06
by California Dreamin
You may need to replace the hub nuts (the ones that peen over to stop themselves coming undone) these can be re-used but after a few times they become damaged. Also take this opportunity to clean and re-pack the wheel bearings with general purpose high melting point grease (don't over pack)
Be careful NOT to load the bearings when re-fitting the hub nut, these vehicles use taper roller bearings so you effectively refit taking the nut down until it touches..the wheel should have slight bearing play when refitted to allow for expansion.
Martin
Re: Front brake disc splash plate
Posted: 22 Mar 2015, 09:32
by garrytheskate
The three fixings that hold the splash plate, is there enough room to fit three hex head screws?