Club 80-90 Forums

The pushrod is available as a separate item
It should be 100mm long
As is the bakerlite spacer...
Remember this is a one way fit...so do't forget how it fits

100mm Push Rod ...
http://www.germancampercompany.com/push ... p-774.html
Pump Pedestal ...
http://www.germancampercompany.com/fuel ... -p-19.html
Pedestal Base Gasket ...
http://www.germancampercompany.com/gask ... p-819.html

There's also another gasket between the pump and the pedestal which is usually fine anyway but can be remade of Cornflake box or even gasket paper if you desire.

Ian

Thanks Kev and Ian for the info on the push rod. I've measured it and its about 96mm long.

I've ordered a full set of bits and gaskets from VW heritage. About £35 with the postage.

Just checking that the push rod goes pointy end down. Into the engine and the pump sits on the flat end ?

Thanks again for the help

Mick

Oops double post. My bad internet connection.

hal2710 wrote: Just checking that the push rod goes pointy end down into the engine and the pump sits on the flat end ?

Yes it does.

Ian

Hi Mick,

Glad our carb experts got you there in the end

I just popped in to say =

hal2710 wrote: I've put a recon 1.9 DG in but still doesn't run great...

next day went for a blast... Under full throttle the power goes

Don't forget you are supposed to be running this motor in a bit

Hi Kev, Ian and all others who helped me with this.


Bertie is fixed ! I've been to the tip and about time too. I need to give Bertie a good clean now.


Thanks again, come round for a cup of tea anytime, you've earned it.


As for me I've learnt another lesson......again.


Mick & Bertie

Yes lesson is never assume..

It makes an ASS of U and ME

kevtherev wrote:Yes lesson is never assume..

It makes an ASS of U and ME

An Ass of me........ NOT "kevtherev"