Club 80-90 Forums

metalmick8y wrote:Made the donation yet
mike

well this is my dinner for the foreseeable future

that looks a low bean count. now whos brand are they? thin juice ,in fact palid looking juice, got to be an own brand, so who's down your way..
will have a think about that one

just got a set of £1 vouchers of weetabix as a pack I got had flaky weetabix not firm and compacted, its seriouse they virtually disolved in milk, any how emailed a complaint and gotr a nice response plus the vouchers, also found out why some inner sleeves have weetabix printed and some dont,
they are all made /packed on the same line but the catering ones get shipped different and so have the product ID on the sleeve and what happens is that they do a run and pack too many this way and these extras end up in retail packs

Also if you check when you get BOGOF's often they may be flaky and hence sold cheap. if so eat a few and complain direct for voucehers and also get your refund next time in the store .

well I was bored late the other night
M

their not my beans Mike..its just a pic off google..for effect like.
and how are you on shredded wheat..i aint had that for yonks...i might buy some and complain they are too stringy and get me some vouchers too

Hah yes, they look crap beans, shreddies,I dont like them but hey joking aside its always worth a nice email to complain.
mike

still think it was left to right

I know you do but why? I mean what part of the weld makes you think that and why? we both weld and both mig amongst other ways and I reckon I might crack the welder up and do a few tommorow to check
mike

i dunno

me and weldore appologise for jacking the thread weve gone elsewhere for now.

carry on

Back from the dust bowl. Happy New year all!

Ok... Ok... I know I've been away for a while with work and winter and .... However, spring is in the air and the sun is out so today so I got my tools out and started on the rear fridge side 1/4.

Update before xmas:


After:



Today:
I have a replacement wing to put in here. Also, I need a trolley jack and some axle stands.

Sun is out so cracking on...

Some pictures of the rear arch replacement.

Put a good shift in today. I'm using self tappers to pull the arch and side and floor together before welding.

Rain does not stop play. Thank you Rolson

Reached my first milestone today - Managed to set the van on fire, well the rubber stuff under the van anyway.

Installed some insulation today. First I installed some foil backed flashing tape in each horizontal recess to add some mass to the panel and reduce vibrations. Then used some 50mm xtratherm to provide insulation. I used some poly spacers to ensure an air gap behind the foam. Next I will seal join and stuff gaps with regular recycled plastic insulation stuffed into tough plastic bags. over this there will be bubble foil which will act as the vapour barrier and additional insulation.